Upgrade zdroje pro HP Compaq Elite 2000 CMT
Dobrý den chtěl bych se zeptat jestli se dá sehnat nějáký zdroj pro HP Compaq Elite 2000 CMT, tento počítač má na základní desce nestandartní konektory a potřebuju tam zapojit grafickou kartu s 8 pinem, pokud by to bylo možné chtěl bych buď nový zdroj s minimální výkoností 600 W nebo nějáký externí zdroj pro tuto grafiku [odkaz, pro zobrazení se přihlaste], tedy pokud něco takového existuje.
Díky za odpovědi Mikis
Díky za odpovědi Mikis
Byl by odkaz na ten počítač? Google o HP Compaq Elite 2000 CMT moc neříká. Není to HP Compaq Elite 8000? Ten stávající zdroj nemá aspoň 6pin?
zde je odkaz http://www.hpmarket.cz/productOpt.asp?konfId=XY139EA, nemá žádné volné kabely a omlouvám se není to HP Compaq Elite 2000 ale Compaq Elite 8200
Našel jsem tohle http://www.newegg.com/Product/Product.aspx?Item=N82E16817104054
Mělo by to pomoct ale nevím kde koupit.
Mělo by to pomoct ale nevím kde koupit.
Bez záruky.
http://h30434.www3.hp.com/t5/Desktop-Gaming-Read-Only/Upgrading-PSU-in-Elite-8200/td-p/885637
[QUOTE]Hi, you can use a ATX-PSU if you do some rewiring:
1: The 4-pin cpu contact is ok as it is.
2: Clip the 12v, -12v and GND from the 24pin ATX and wire it to the 6-pin MB contact (color coded)
3: Take the "Pwr good" from the ATX- contact and put it on the small 6 pin HP special contact (grey I think) (clip the others on this special contact)
4: Use a external switch to ground the green "Ps_ON" from the PSU ATX contact.
5: Set in bios that it will start automatically after power loss.
Now you can start the computer via the new external switch.
You will have to press F1 during startup because it complains about the PSU fan is not detected.
(The pro & elite series is steering the PSU fan from the Motherboard)
I used a z400 475W PSU... it fits perfect in the case[/QUOTE]
http://h30434.www3.hp.com/t5/Desktop-Gaming-Read-Only/Upgrading-PSU-in-Elite-8200/td-p/885637
[QUOTE]Hi, you can use a ATX-PSU if you do some rewiring:
1: The 4-pin cpu contact is ok as it is.
2: Clip the 12v, -12v and GND from the 24pin ATX and wire it to the 6-pin MB contact (color coded)
3: Take the "Pwr good" from the ATX- contact and put it on the small 6 pin HP special contact (grey I think) (clip the others on this special contact)
4: Use a external switch to ground the green "Ps_ON" from the PSU ATX contact.
5: Set in bios that it will start automatically after power loss.
Now you can start the computer via the new external switch.
You will have to press F1 during startup because it complains about the PSU fan is not detected.
(The pro & elite series is steering the PSU fan from the Motherboard)
I used a z400 475W PSU... it fits perfect in the case[/QUOTE]